Tarpaulins What tarpaulin / tarp welding machine fits your production needs?
Miller Weldmaster manufactures a variety of equipment for the production of tarpaulins / tarps, truck tarps, and covers. Miller will design a completely automated machine to fit you specific tarp production needs. Take a look at the equipment below and see how you can instantly increase your production while decreasing labor cost.
Click here for how to contact us!
Equipment for welding various tarps / tarpaulins, truck tarps, and covers:
Systems for the production of various tarpaulins / tarps, tuck tarps, and covers:
| M-100 Tarpaulin Machine This M-100 pulls fabric off of multiple rolls and welds up to 7 overlap seals and hems on both edges. This system also marks a perpendicular and lateral D-ring layout line and cuts to a desired length. Tarp production video |
| M-100 Keder and Tarp Machine This M-100 pulls fabric off of two unwinds and welds an overlap while simultaneously creating and welding a two-sided keder to each edge of the finished panel. Tarp Keder production Video |
| M-100 Truck Side Tarp Machine This M-100 pulls fabric off an unwind and welds multiple webbings and reinforcement strips simultaneously while cutting the products to length. Truck side production video |
| M-100 Large Covers This M-100 pulls fabric off of multiple rolls and is designed to weld up to three overlap seams and rewind the final product. The resulting roll is only 12 ft. wide when rewound, but unfolds to 48 ft wide. Truck side production Video |
| 112 Indexing System - Truck Side Tarpaulin These fully automated systems are designed to dispense and weld webbing strips in pre-determined locations while indexing the panel to its next location. Truck side production video |
| M-100 Mesh Tarpaulin This M-100 was designed to pull fabric off roll and weld hems on both sides while simultaneously punches grommets on both edges. This system is also designed to cut to length while continuously welding. Mesh Tarp production video |
| M-100 Large Covers This M-100 was designed to adjoin two rolls of multi-layered pre-folded blown film with a fold overlap seam. This system will then cut the product to length or rewind it into master rolls for distribution. Large Covers Video |
| Custom System - Truck Side Curtains This custom automated system was designed to weld webbing in both the horizontal and vertical direction on four curtains at the same time with the use of a large vacuum table, and automatic dispensing and cut to length welding heads. Truck side production Video |
|
|
|
|
||||||||||||||||||||||||||||||||||||||||
