Learn how to adjust the wedge position on your T300 machine!
This tech tip demonstrates the proper way to adjust your wedge guide on your T-Series Machine. As you can see, the wedge is not properly aligned with the wheels. This will not provide a quality seam.
To correct this:
- Hold the arrow button and bring the wedge over to the right.
- Continue to use the arrows to adjust the wedge until it is positioned properly
- Take the wedge in between the wheels.
- Look from the side to make sure the wedge is in the right position.
- Use a brush, screwdriver, or anything else to check if the tip is loose because you're going to want to hit the bottom of the roll and then go up to the top one.
- Walk the wedge millimeter by millimeter using the arrows on the screen.
- Once you're in your position, press the Save button on the top right and go back to the main page with the button next to it.
Now you’ll have the wedge in that position every time you go in and weld.
Need Additional Help?
Email service@weldmaster.com to open a service ticket today!